Dodge Truck Installation Instructions

This kit is designed to add adjustability to the factory supplied system to compensate for torsion bar sag and fatigue.

Applications Include:

• Dodge Ram 4x4 R1500
• 2002 - 2005
• Standard Cab
• Extended Cab

Ramcams are designed to add additional height adjustment to your vehicle. Under no circumstances should the truck be adjusted beyond the factory height measurement. The shock absorber is the suspension height limiter and only stock length shock absorbers are recommended without modification whatsoever.

Adjusting vehicle suspension height beyond the maximum factory height can cause binding of crucial steering and suspension components.

These instructions and warnings shall not be substituted for the factory service Manual Torsion bars are preloaded in the vehicle. Only experienced suspension technicians with a working knowledge of the system and the properly designed tools and Safety Equipment should attempt installation of this part.

Installation of this product and all the adjustments should be performed by a licensed certified technician. Using the correct tools and procedures. Adjusting the suspension beyond the factory recommended maximum height can cause binding and accelerated wear of critical steering and suspension parts. Under no circumstances shall Suspension Maxx or its parent company Gary's Safety Center be held liable for any damage or loss of use due to incorrect installation of adjustment. Purchaser of this product assumes all liability.

Calibration is required before installation.

Pat. Pending

• To calibrate match A or B stamped on the internal hub with the appropriate numbered outer position.
• Apply Anti-seize on gear tooth area to ease future disassembly
• Install hub retainer clip
• Reinstall MAXXCAM 2 in vehicle
• Remove hub retainer clip and discard
• Adjust suspension ride height within specified range
• Wheel alignment required after installation